Abstract
Laser doping is an attractive way to manufacture a selective emitter in high efficiency solar cells, but the underlying phenomena, which determine performance, are not well understood. The mathematical model developed in Part I solves the equations of conservation of mass, momentum, and energy and is used here to investigate the effects of processing parameters on molten zone geometry, average phosphorus dopant concentration, dopant profile shape, and sheet resistance. The empirically calculated sheet resistance values are in good agreement with independently measured sheet resistance values reported in the literature. Process maps for output power and travel speed show that molten zone geometry and sheet resistance are more sensitive to output power than travel speed. The highest molten zone depth-to-width aspect ratios and lowest sheet resistances for 532 nm laser beams are obtained at higher laser powers (>13 W) and lower travel speeds (<2 m/s). Once the power level is set, the travel speed can be varied for further optimization of dopant concentration and geometry.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
