Abstract
Laser induced backside wet etching combined with the diffractive gray tone phase mask has been used for the fabrication of a micro-lens array with a single lens diameter of 1 mm and a micro-prism in quartz. The micro-lens array was tested as beam homogenizer for high power XeCl excimer laser yielding a clear improvement in the quality of the laser beam. The optimum fluence range for fabrication of micro-lenses by laser induced backside wet etching using 1.4 M pyrene in THF solution and 308 nm irradiation wavelength is 1–1.6 J/cm 2. The etching mechanisms of LIBWE are based on a combination of pressure and temperature jumps at quartz–liquid interface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
