Abstract
In this work the fabrication of strain sensors based on the resistive principle using inkjet printing of silver nanoparticles was investigated. Laser sintering was studied as an alternative sintering process. Printed on polyimide substrate silver structures were sintered using a continuous wave 405 nm diode laser. Gauge factors of printed strain gauges of around 3.6 (after laser sintering) have been achieved.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.