Abstract
We have developed a laser and focused ion beam (FIB) compound process for press mold dies of a micro lens array (MLA) and a micro needle array (MNA) in a glassy carbon (GC). The press mold die of the MLA was roughly fabricated by UV-YAG laser. After this process, we finished this surface by scanning FIB. As a result, higher accuracy and good roughness of surface profile can be realized. An optical glass is used to confirm the shape of lens. Moreover, we fabricated 6 × 6 through-holes in the GC by the spiral drilling in addition to the focus position movement of the UV laser for press mold die of the MNA. After the FIB process, we were able to make the needle die of surface and hole wall roughness less than 0.9 μm. A silicon rubber is used to confirm the shape of the holes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.