Abstract
A series of hypervelocity damage experiments were performed on spacecraft materials in order to simulate micro-size space debris traveling at 3 to 8 km/s. Two types of impact simulations were investigated: high-power pulsed laser and laser-launched micro-flyer plate. In the first case a laser was used to generate a high-pressure shock wave which propagated into the target by means of rapid ablation of the target surface. The second case used the same laser to accelerate micro-flyer plates at a target. The laser-ablation technique and the apparatus used to propel the micro-flyer plates were compatible with a space environmental chamber equipped with instrumentation capable of analyzing the vapor ejected from the sample. Data obtained from two separate damage effects were of interest in this study: the vapor blow-off produced by the impact and the mechanical damage to the target. The value of the data obtained from both simulation methods was evaluated in terms of likeness to actual space debris damage. Data for this work were obtained from polysulfone resin and a graphite polysulfone composite. Polysulfone was selected because it was flown on the Long Duration Exposure Facility (LDEF) satellite which spent several years in low earth orbit and experienced many space debris impacts. The chemistry of the vapor produced by the two simulation techniques was analyzed with a time of flight mass spectrometer (TOFMS) which measured changes in the vapor chemistry as a function of time after impact, obtained a velocity measurement of the vapor, and estimated surface temperature immediately after impact using dynamic gas equations. Samples of the vapor plume were also captured and examined by transmission electron microscopy (TEM). The mechanical damage effects caused by the simulation methods on a graphit polysulfone composite and a polysulfone resin were studied. Impact craters were examined under optical and scanning electron microscopes (SEM). Based on the two damage effect criteria the micro-flyer method proved to be a useful way to simulate hypervelocity impact of space debris. The laser-ablation method however, had shortcomings and required drastic compromises in the set criteria.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.