Kirschner wire creates more microdamage than standard or acrylic drill bits in the rabbit (Oryctolagus cuniculi) femur.

Abstract

Histologically evaluate damage to rabbit femur after the creation of bicortical 1.5-mm-diameter holes using a standard surgical drill bit, an acrylic drill bit, and a Kirschner wire (K-wire). 10 femora (5 pairs) from skeletally mature female intact New Zealand white rabbits were used. The bone diaphyses were divided into 4 locations, systematically undergoing each test (surgical drill bit, acrylic drill bit, K-wire, and intact control). Four pairs were drilled using a mechanical testing machine, and 1 pair was drilled by hand. Cross-sections of the bone were stained en bloc with basic fuchsin for undecalcified histological evaluation. Damaged bone was reported as a percentage of a standardized area and categorized by location (cis- or transcortex), drill contact (entrance or exit of the cortex), and total damage (both cortices). The drilling method (hand vs mechanical testing machine) had no effect on histologic damage, so results were analyzed by combining all data. The K-wire demonstrated the greatest area of cracks/damage compared to both standard surgical and acrylic drill bits, whereas no difference in damage was noted between the 2 drill bits for all variables. The K-wire and drill bits caused microdamage; K-wire drilling created more microdamage than drill bits. The rabbit bone cortex is thin and brittle relative to dogs and cats, leading to failure during and after fracture fixation. The clinical failure of rabbit bone is at least partially caused by drill bits or K-wires causing microcracks.