Kinetics of particle deposition in the oblique impinging jet cell

Abstract

A new oblique impinging-jet (OBIJ) cell was developed, suitable for colloid deposition studies at various interfaces. In contrast to previously used orthogonal cells, the OBIJ construction makes possible direct microscope observations of particle deposition on nontransparent substrates. The cell performance was tested by studying kinetics of polystyrene latex particle deposition on mica. Two limiting cell configuration were used in the experiments: (i) the lower position (inverted microscope observation of substrate surface through air) and (ii) the upper position (observation of the substrate surface with adsorbed particles through the suspension layer). The dependence of local mass transfer rate (particle flux) on the position over the substrate surface was studied for various flow Reynolds numbers. It was demonstrated that deposition rate attained maximum at the flow stagnation point whose position was dependent on Re number. Moreover, it was shown that the local flux decreased at much slower rate when moving in the downstream direction, than for previously used impinging-jet cells. Consequently, the area of uniform transport conditions was larger, enabling more precise determination of the limiting particle flux at the stagnation-point. The dependence of the flux on Re number was systematically studied for various ionic strength of the suspension. It was demonstrated, in accordance with previous results for the ordinary impinging-jet, that the flux increased significantly for low ionic strength and high Re number. This phenomenon, referred to as the inverse salt effect, was interpreted in terms of the convective diffusion theory. The governing transport equation originating from this theory was solved numerically, for the region near the stagnation point, using the finite-difference method. These numerical solutions were used for nonlinear fitting of the flow intensity parameter dependence on the Re number. In this way the flow field in the vicinity of the stagnation point was fully characterized. It was concluded that the new cell can be exploited as an effective experimental tool for colloid deposition studies on various substrates.