JUSTIFICATION OF THE POSSIBILITY OF USING THERMOMODIFIED VENEER IN AN ENVIRONMENT WITH HIGH HUMIDITY

Abstract

Thermally modified wood is widely used in the woodworking industry, as it has increased resistance to environmental factors (humidity, temperature). The effect of high temperature on wood causes a decrease in water adsorption by reducing the available free hydroxyl groups of carbohydrates. The reduction in hygroscopicity contributes to the treated material size stability, as swelling and shrinkage are mainly associated with the phenomena of absorption and water desorption. The study of natural weathering always takes many years. Therefore, to study the resistance of thermodified wood to environmental influences, artificial weathering is used - modeling of external factors (cyclic change of UV light and moisture). The effectiveness of the thermodified veneer use as a material for lining the furniture facades which working in different temperature and humidity conditions was established. The values of moisture and water absorption on the samples of oak veneer, which have previously undergone the heat treatment process, have been determined. It was found that the samples of oak veneer gained the most moisture from the environment in the first two days. The weight of unmodified veneer increased by 0.06 g, similar results showed veneer modified at temperatures of 160 and 190 °C. Thermodified veneer at a temperature of 250 °C for the first two days gained twice less. By the end of the experiment (next 11 days), the samples of ordinary and modified veneer at all temperatures absorbed the same amount of moisture. Untreated veneer and thermodified at temperatures of 160 and 220 °C absorbed 50-66 % of its initial weight, and modified at 250 °C – 20-36 %. Control samples of veneer during the determination of water absorption gained 98 % of the initial weight. Samples modified at 160 °C – 10, 20, 30 min showed the best result – reducing the value to 94 %, 93 % and 91 %. There is a slight improvement in water absorption after exposure to temperature 220 °C for 10, 20, 30 min – 91 %, 91 % and 90 %. Values water absorption at the level of 90 %, 89 % and 86 % were recorded in veneer samples modified at 250 °C.