Abstract
Additive manufacturing (AM) of many traditional aluminum alloys is difficult due to hot cracking during cooling, which motivates investigating alternative AM methods that can mitigate this challenge. Here we demonstrate a new pneumatically driven molten metal jetting (MMJ) AM technique which uses a longer pressure pulse width to produce a jet of liquid metal that reaches the heated build plate. The “jet on demand” technique is utilized to build Al-6061 parts on heated build plates. Due to the large thermal mass contained in each jet, excellent adhesion is observed between droplets and layers while still maintaining dimensional control to produce parts with high relative densities (>98%). While as-printed parts exhibit different microstructure and hardness than traditional Al-6061, both microstructure and hardness are restored to traditionally processed values through a traditional T6 heat treatment. Microhardness values of 104 HV were obtained for printed Al-6061, which compares well to wrought properties. We observe that high build plate temperatures allow for lower solidification rates and eliminate hot cracking. These results point to a method for additively manufacturing traditional aluminum or other alloys that cannot currently be additively manufactured due to hot cracking.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
