Abstract

GaAs was grown by molecular beam epitaxy (MBE) and ion-assisted MBE on Si(100) substrates. Three-dimensional (3D) island nucleation, observed during MBE growth, was eliminated during ion-assisted MBE when the ion energyE was >25 eV and the product ofE and the current densityJ was ≈6-12 eV mA/cm2. IncreasingEJ to ≈15 eV mA/ cm2 resulted in excessive ion damage. Decreasing the substrate temperature from 280 to 580° C during ion-assisted MBE yielded a slight decrease in surface roughness, and flatter surfaces were obtained for lower As4/Ga flux ratios. The suppression of 3D island nucleation led to an improvement in the crystalline perfection of thicker GaAs films. For example, the x-ray diffraction rocking-curve full-width-at-half-maximum values for 0.5 μm thick films grown at 380° C decreased from 1700 arcsec to 1350 arcsec when ion irradiation was used during nucleation. IAMBE allowed nucleation of thin, relatively flat-surfaced GaAs films even at 580° C, resulting in FWHM values of 1850 arcsec for 0.14 /μm thick films.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.