(Invited) Defect Photoluminescence Generation in Boron Nitride Nanotubes by Chemical Functionalization Approaches

Abstract

Boron nitride nanotubes (BNNTs) are structural analogues of carbon nanotubes (CNTs). They have nanocylindrical structures composed of rolled-up hexagonal boron nitride (h-BN) sheets. The BN framework consists of alternately connecting boron and nitrogen atoms with sp2 hybridization. Therein, a strong covalent bond with an ionic character is formed due to their electronegativity difference. Accordingly, BNNTs exhibit unique properties such as high mechanical strength, thermal stability, and a wide bandgap semiconducting feature [1]. The large bandgap (ca. 6 eV) is less dependent on tube diameters and chiralities, and optical absorption and emission for pristine tubes occur in deep UV regions (around 200 nm) based on the band edge transition. In typical BNNT samples, however, atomic vacancies in the BN framework are reported to provide longer wavelength photoluminescence (PL) in UV–vis regions [2].To date, chemical functionalization of single-walled CNTs (SWCNTs) have been developed to create luminescent defects emitting red-shifted and bright near-infrared PL [3-6]. In this study, we use the chemical functionalization method to produce luminescent defects in BNNTs [7].A reductive alkylation reaction for BNNTs was conducted using sodium naphthalenide and 1-bromohexane to synthesize hexylated BNNTs (h-BNNTs). In a PL spectrum of h-BNNTs, PL peaks appeared at 334 and 413 nm, which were not observed for unmodified BNNTs. X-ray photoelectron spectroscopy revealed that the hexyl group was covalently attached on the boron site of BNNTs, by which sp3 hybridized boron atoms were partly formed in the BN network as defects. The covalent attachment of the hexyl group was also confirmed by atomic-resolution transmission electron microscope observations. Chemical reaction conditions were found to be a key factor for the emission wavelength variations of the resultant defect PL. Therefore, it is revealed that the luminescent defect formation in BNNTs is achieved based on the chemical functionalization approach. The functionalized BNNTs would be applicable to advanced optical applications such as quantum light sources.[1] D. Golberg et al. ACS Nano,4, 2979 (2010). [2] L. Museur et al. J. Appl. Phys., 118, 084305 (2015). [3] T. Shiraki et al. Acc. Chem. Res., 53, 1846 (2020). [4] B. Gifford et al. Acc. Chem. Res., 53, 1791 (2020). [5] A. H. Brozena et al. Nat. Rev. Chem. 3, 375 (2019). [6] J. Zaumseil. Adv. Opt. Mater. 10, 2101576 (2022). [7] T. Shiraki et al. Chem. Lett. 52, 44 (2023). Figure 1