Investigation of vibratory bed effect on abrasive drag finishing: a DEM study

Abstract

Purpose The purpose of this paper is to investigate the effect of a vibratory bed, as an assistant agent, on the improvement of the drag finishing process. The dynamics and kinematic of the process were surveyed in microscale for different frequencies and amplitudes and the results were compared to the basic process. Design/methodology/approach The discrete element tool was used to find out the effect of the vibratory bed on the drag finishing process. To this end, the Hertz-Mindlin model was used to investigate the contact of abrasive particles and workpiece. At the first stage, the numerical model was validated with the experimental results, and then the effect of different parameters on the finishing process was evaluated and compared with the basic case. Findings The chosen numerical model was in good agreement with the results measured in the previous literature. Moreover, the results show that not only vibrated bed enhances the contacts of abrasive particles to the workpiece, but it also increases the uniformity of the finished surface. Originality/value In comparison to the experiments, the discrete element technique consumes lower cost and time to estimate the optimum conditions of the finishing process, as well as it provides a good understanding of this phenomenon on the micro-scale.