Abstract

The braking system is the most significant active safety system that converts the vehicle’s mechanical energy into heat energy based on the braking pair’s friction. In this paper, temperature-friction coefficient variation, disc thickness variation, and coning are investigated with the Fade I test procedure is performed according to the SAE J2522 comprehensive brake efficiency test standard. In these investigations, the combined or discrete effects of the peripheral speed factor, the temperature increase with the braking time, thermal expansion and increased friction coefficient values have been decisive on the increase in the disc thickness variation from the inner part to the outer part. The thermo-mechanical behavior of the disc for the same test procedure is demonstrated in ANSYS® software using the finite element method. Steady-state thermal analysis method is chosen, and then total deformation and von Mises stress conditions are evaluated by using transient structural analysis with thermal analysis results and experimental data. At the end of braking, the deformation has reached its 0.28872 mm (maximum) at the outer radius where the pad and disc are in contact, and the maximum von Mises stress value (964.33 MPa) has been obtained. Furthermore, the deformations reached the maximum in the region where the disc temperature reached its maximum during braking revealing that the obtained results are interrelated.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call