Abstract
The research results of the dependence of the magnitude of plastic deformation on the rate of its flow using the example of processing materials by cutting titanium alloys are given in the paper. The process of plastic deformation in titanium alloys is the most interesting. Chip shrinkage characterizes the flow of plastic deformation. The influence of the feed rate on the shrinkage of the chips during turning of the titanium alloy ВТ6 (Russian State Standard GOST 19807-9) has been experimentally determined.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
