Investigation of the Influence of the Roll Surface on the Cast Strip at the Casting Using a Vertical Type High Speed Twin Roll Caster

Abstract

A vertical type high speed twin roll caster can be cast an aluminum alloy strip directly from a melt at high casting speed. However defects of the cast strip occurred at faster roll speed, which includes small cracks on the cast strip and unsoundness thickness distribution. They are related to contact condition of roll surface and melt. In the present study, a grooved roll was used to eliminate the defects and adopted in terms of the cost saving. We experimented using several grooved rolls with different patterns. When the groove width was 0.45mm; depth 0.2mm; pitch 0.1mm and 1.0mm, stable casting was possible. The shape of bulge was formed on the cast strip surface by the grooved roll. As a result of color check, we found that the grooved roll eliminate the small cracks. We stopped the rotated roll during the casting to observe the contact condition between the melt and the roll, and confirmed how the bulge was formed. The as-cast strip with the bulge was able to cold rolling.