Abstract
Abstract Steel/epoxy peel specimens were prepared using ethylene-mercaptoester (EME) copolymer coupling agents (90 wt% mercaptoester units) applied in thickness ranging from 25 to 350 A. An optimum thickness of approximately 140 A, which corresponded to an over 200% increase in peel strength when compared to 50 A thick samples, was determined from ellipsometry and 90° peel strength measurements. The corrosion protection obtained was essentially independent of coupling agent thickness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
