Abstract
Calcium carbonate (CaCO3) nanoparticles were used as sacrificial additives to fabricate PSf substrate membranes and based on which thin film composite (TFC) membranes were prepared using m-Phenylenediamine (MPD) and 1, 3, 5-trimesoylchloride (TMC) as the monomers. Then CaCO3 nanoparticles dispersed in PSf matrix were effectively etched with hydrochloric acid to increase the substrate porosity. The effect of CaCO3 loading (ranging from 0 to 10.0wt%) was systematically investigated. The results showed that the substrate membranes fabricated with CaCO3 incorporation exhibited higher porosity and smaller structural parameter, which is advantageous for improving water permeability and reducing mass transfer resistance. As for forward osmosis (FO) performance, the TFC membranes fabricated using modified substrates exhibited much higher water flux than the control TFC membrane prepared by substrate without CaCO3 incorporation in both AL-FS and AL-DS mode when using DI water as the feed and 2M NaCl as draw solution. The optimized TFC21 membrane also had better performance than other commercial TFC membranes in simulated seawater desalination. Moreover, the reduced membrane structural parameter indicated that the internal concentration polarization (ICP) could be mitigated via the etching method. This study provides a low cost and feasible way to reduce the ICP in FO membranes.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
