Abstract
Micro-injection molding has attracted a wide range of research interests to fabricate polymer products with nanostructures for its advantages of cheap and fast production. The heat transfer between the polymer and the mold insert is important to the performance of products. In this study, the interface thermal resistance (ITR) between the polypropylene (PP) layer and the nickel (Ni) mold insert layer in micro-injection molding was studied by using the method of non-equilibrium molecular dynamics (NEMD) simulation. The relationships among the ITR, the temperature, the packing pressure, the interface morphology, and the interface interaction were investigated. The simulation results showed that the ITR decreased obviously with the increase of the temperature, the packing pressure and the interface interaction. Both rectangle and triangle interface morphologies could enhance the heat transfer compared with the smooth interface. Moreover, the ITR of triangle interface was higher than that of rectangle interface. Based on the analysis of phonon density of states (DOS) for PP-Ni system, it was found that the mismatch between the phonon DOS of the PP atoms and Ni atoms was the main cause of the interface resistance. The frequency distribution of phonon DOS also affected the interface resistance.
Highlights
With the rapid developments of micro-electro-mechanical systems (MEMS), parts containing nanostructures can be used in self-cleaning surfaces [1], lab-on-chip devices [2], biomedical detection [3], optical technology [4] and other fields
During micro-injection molding of nanostructured parts, the interfacial heat transfer between the filled polymer and the mold insert will affect the quality of nanostructures [7,8,9]
It is believed that the interfacial thermal resistance is an important parameter to study the interfacial heat transfer characteristics in micro-injection molding for nanostructures
Summary
With the rapid developments of micro-electro-mechanical systems (MEMS), parts containing nanostructures can be used in self-cleaning surfaces [1], lab-on-chip devices [2], biomedical detection [3], optical technology [4] and other fields. Micro-injection molding has aroused extensive research interests to fabricate polymer products with nanostructures due to its advantages of low cost and short cycle [5,6]. During micro-injection molding of nanostructured parts, the interfacial heat transfer between the filled polymer and the mold insert will affect the quality of nanostructures [7,8,9]. It is believed that the interfacial thermal resistance is an important parameter to study the interfacial heat transfer characteristics in micro-injection molding for nanostructures. The interface thermal resistance (ITR) is not equal to the thermal contact resistance (TCR). The ITR refers to the thermal resistance of two surfaces in full contact at the atomic scale, while the TCR refers to the thermal resistance caused by the gap Polymers 2020, 12, 2409; doi:10.3390/polym12102409 www.mdpi.com/journal/polymers
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
