Investigation of High-Temperature Oxidation Behavior of Additive Manufactured CoCrMo Alloy for Mandrel Manufacturing

Abstract

The cyclic oxidation behavior of an additive manufactured CoCrMo alloy with 0.14 wt.% C was investigated at 914 °C for 32 cycles, each lasting 10 h, resulting in a total exposure time of 320 h. The oxidation rate was assessed for mass gain after finishing each 40 h oxidation cycle. It was experimentally determined that the oxidative process at 914 °C of this CoCrMo alloy follows a parabolic law, with the process being fast at the beginning and slowing down after the first 40 h. The microstructural analysis revealed that in the as-printed state, the phases developed were primarily the γ matrix and minor traces of ε phase. The oxidative process ensured an increase in the ε phase and precipitation of carbides which produced a 12% increase in the material’s hardness after the first 40 h of exposure at 914 °C. The oxidation process led to the development of an oxide scale comprising a dense Cr2O3 layer and a porous layer of CoCr2O4 spinel, the latter spalling after the 240 h of exposure. Despite this spallation, the oxide scale continued to develop in the presence of O, Cr, and Co. The experimental analysis provided valuable insights regarding the material’s behavior under prolonged exposure at high temperature in air, demonstrating its suitability as a candidate for additive manufactured mandrels used for bending metallic pipe fitting elbows.