Investigation of heat transfer and damage characteristics of high pressure abrasive water jet impacting high temperature sandstone

Abstract

ABSTRACT Efficient breaking of hard mineral rocks is an important prerequisite for deep metal mining. In order to study the rock breaking mechanism of abrasive water jet erosion of high-temperature hard rock in deep ground, the temperature deformation evolution law during the process of jet impact on rocks was simulated and experimentally studied. The results show that the distribution of jet pressure, jet velocity, and jet turbulent kinetic energy near the residence point of the jet impingement wall is generally high in the middle and low in the outside. The heat transfer distance r on the rock surface is approximately (1.5–2.0) times the nozzle diameter, and the heat transfer distance inside the rock is (1.0–1.5) times the nozzle diameter. The maximum heat flux density at the jet cooling wetting boundary can reach 450 W/mm2. Within 0–3 seconds of the erosion process, the average surface temperature sharply decreases and exhibits a downward trend of jet stagnation point radiating outward. The radius of jet cooling influence gradually increases. Due to the impact cooling effect, tensile stress is generated at the top of the rock sample, and the tensile stress in the lower part of the rock is converted into compressive stress. With the increase of jet pressure and treatment temperature, the area and range of erosion pits significantly increase, and there is a significant phenomenon of thermal cracking around the erosion pits. The research conclusion can provide new ideas and basis for hydraulic breaking of high-temperature hard rocks in deep ground.