Abstract
Two typical topology shapes of the microstrip meander line (MML) including round U-shaped and V-shaped slow-wave structure (SWS) for <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">${D}$ </tex-math></inline-formula> -band traveling wave tubes (TWTs) are comparatively investigated, fabricated, and tested in this article. As a critical factor applied in millimeter-wave frequency, the high-frequency losses of the MML SWS are emphatically discussed. The two types of golden SWSs are both fabricated with the thin-film circuit technology on quartz substrates. After the surface roughness test and the cavity fabrication, the SWS samples are assembled and tested. According to the experimental test results, the <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">${S}_{11}$ </tex-math></inline-formula> parameters of the U-shaped and V-shaped transmission models are below −13.5 dB versus −15 dB, and the “cold” <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">${S}_{21}$ </tex-math></inline-formula> parameters are over −6.4 dB versus −4.9 dB, which are approached to the simulation results with the consideration of the silver conductive paste (SCP). At 140 GHz, the tested transmission losses for the U-shaped SWS and V-shaped SWS are about 0.35 and 0.29 dB/mm, respectively. Although particle-in-cell (PIC) simulations for the two SWSs both predict more than 100-W output power, the V-shaped MML TWT shows better bandwidth and loss performances than the U-shaped MML TWT.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.