Abstract
The importance of the state of cure of elastomer components with regard to fatigue behavior and thus also durability was already discussed in more detail in Part 01 of the paper. It was shown that crosslinking time and temperature have an enormous influence on the crack growth behavior in nitrile butadiene rubber (NBR). In the course of this, a fourfold deceleration in crack growth was observed with a 20 K increase in manufacturing temperature. To confirm this trend, test specimens were produced at 180 °C. Crack growth was found to be 40 times slower, especially in high tearing energy ranges, compared to 150 °C. To analyze the observed behavior in more detail, cylindrical samples were taken from the plain strain test specimens (used for the crack growth measurements), and multi-stage swelling was performed with them. This allowed a detailed analysis of the degree of cure and the sulfur chain composition. It was found that the crosslink density decreases with increasing manufacturing temperature due to decomposition and the proportion of polysulfidic crosslinks decreases with increasing heating time due to desulfurization. Furthermore, a correlation between the results found by means of the rubber process analyzer (RPA) and the swelling results could be established looking at the maximum transmitted torque during the isothermal crosslinking phase.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
