Abstract

In our experiment, the possibility of forming copper wire bonds in Chip-on-Board (COB) applications was investigated. In the experiment, such surface finishes were studied and compared which are common in printed circuit board based COB applications and can be bonded with wire bonding technologies. These finishes were immersion silver (ImAg), electroless nickel / immersion gold (ENIG) and electroless nickel / electroless palladium / immersion gold (ENEPIG). On each type of surface finish, copper wires with two diameters (33 and 300 μm) were bonded with a TPT Ultrasonic bonder. The wire bonds then characterized by optical inspections and mechanical measurements which are detailed in the paper.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.