Interpenetrating Freeze Cast Composites: Correlation between Structural and Mechanical Characteristics

Abstract

Ceramic freeze cast preforms based on alumina show an anisotropic behavior due to directional freezing during preform production. Beside the specific characteristics such as alumina content and lamellae spacing also the distribution of the so-called domains – regions with a relatively homogeneous orientation of alumina lamellae – play an important role considering stiffness and strength. The gas pressure infiltration process was used for infiltrating the freeze cast preforms with a eutectic aluminum/silicon alloy with a low melting point. Selected regions taken from the freeze cast preform have been analyzed via X-ray micro computed tomography (µCT) prior to the infiltration due to a higher contrast in comparison to the infiltrated preforms. The orientation of the lamellae has been determined from the three dimensional data with an algorithm which is based on the structure tensor. The mechanical stability - in terms of the strength - of the infiltrated preforms has been quantified via quasi static compression tests on cuboid samples. The results show a good agreement between the orientation of the lamellae distribution and the maximum strength of the preform which could also be verified using an analytical model.