Abstract
Creep tests were conducted on directionally solidified TiAl-Si alloys to discern the effect of lamellar spacing and lamellar orientation on the high-temperature strength. Directional solidification of a Ti-43Al-3Si alloy was used to produce a model microstructure consisting of a single γ/α2 lamellar colony of controlled orientation for creep testing. Different heat treatments were used to vary the lamellar spacing and tensile creep tests were performed at 750 °C using applied stresses of 180, 210, and 240 MPa. In addition, ingots with large columnar grains of various lamellar orientation were also tested. The results clearly show the beneficial effect of microstructural control with the aligned microstructure having a much superior creep resistance. Furthermore, for specimens with aligned lamellar microstructure, decreasing the lamellar spacing greatly improved creep resistance, as both the primary creep strain and secondary creep rate are much smaller for materials with the fine lamellar spacing.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
