Intermetallic compound formation in Sn-Co-Cu, Sn-Ag-Cu and eutectic Sn-Cu solder joints on electroless Ni(P) immersion au surface finish after reflow soldering

Peng Sun Peng Sun,Xicheng Wei Xicheng Wei,Zhaonian Cheng Zhaonian Cheng,Dongkai Shangguan Dongkai Shangguan,J Liu,C Andersson

doi:10.1109/hdp.2006.1707608

Peng Sun Peng Sun, Xicheng Wei Xicheng Wei + Show 4 more

https://doi.org/10.1109/hdp.2006.1707608

Copy DOI

Abstract

The interfacial reactions between Sn-0.4Co-0.7Cu eutectic alloy and immersion Au/electroless Ni(P)/Cu substrate were investigated after reflow soldering at 260degC for 2 minutes. Common Sn-4.0Ag-0.5Cu and eutectic Sn-0.7Cu solders were used as reference. Two types of intermetallic compounds (IMC) were found in the solder matrix of the Sn-0.4Co-0.7Cu alloy, namely coarser CoSn2 and finer Cu6 Sn5 particles, while only one ternary (Cu,Ni)6 Sn5 interfacial compound was detected between the solder alloy and the ENIG (electroless nickel and immersion gold) coated substrate. The same trend was also observed for the Sn-Ag-Cu and Sn-Cu solder joints. Compared with the CoSn2 particles found in the Sn-Co-Cu solder and the Ag3Sn particles found in the Sn-Ag-Cu solder, the Cu6Sn5 particles found in both solder systems exhibited finer structure and more uniform distribution. It was noted that the thickness of the interfacial IMCs for the Sn-Co-Cu, Sn-Ag-Cu and Sn-Cu alloys was 3.5mum, 4.3mum and 4.1mum, respectively, as a result of longer reflow time above the alloy's melting temperature since the Sn-Ag-Cu solder alloy has the lowest melting point

Full Text