Interfacial Electronic Interaction in In2O3/Poly(3,4-ethylenedioxythiophene)-Modified Carbon Heterostructures for Enhanced Electroreduction of CO2 to Formate.

Abstract

Formate, as an important chemical raw material, is considered to be one of the most promising products for industrialization among CO2 electroreduction reaction (CO2RR) products, but it still suffers from poor selectivity and a low formation rate at a high current density on account of the competitory hydrogen evolution reaction. Herein, the heterogeneous nanostructure was constructed by anchoring In2O3 nanoparticles on poly(3,4-ethylenedioxythiophene) (PEDOT)-modified carbon black (In2O3/PC), in which the PEDOT polymer interface layer could immobilize In2O3 nanoparticles and obtain a notable reduction in electron transfer resistance among the In2O3 particles, showing a 27% increase in the total electron transfer rate. The optimized In2O3/PC with rich heterogeneous interfaces selectively reduced CO2 to formate with a high FE of 95.4% and a current density of 251.4 mA cm-2 under -1.18 V vs RHE. Also, the formate production rate for In2O3/PC was up to 7025.1 μmol h-1 cm-2, surpassing most previously reported CO2RR catalysts. The in situ XRD results revealed that In2O3 particles were reduced to metallic indium (In) as catalytic active sites during CO2RR. DFT calculations verified that a strong interface interaction between In sites and PC induced electron transfer from In sites to PC, which could optimize the charge distribution of active sites, accelerate electron transfer, and elevate the p-band center of In sites toward the Fermi level, thereby lowering the adsorption energy of *OCHO intermediates for CO2 conversion to formate.