Abstract
In this paper, integrated control design for the pneumatic servo table system considering the dynamics of pipelines and servo valve is studied. The table is mainly composed by a pneumatic actuator, a highperformance pneumatic servo valve and pipelines. The pneumatic actuator utilizes a pneumatic cylinder with air bearings. The servo valve has high dynamics up to 300 Hz and is connected to the pneumatic actuator by pipelines. The system is pneumatically driven, providing the advantages of low heat generation and non-magnetic, nature suited to precise positioning. To simulate the system, we designed a linear model considering pipelines and servo valve dynamics. Comparison results showed that with a 7thorder linear model, the discrepancy between experiment and simulation results was much smaller than when using a 3rdorder model. The model’s complexity made it necessary to reduce the model’s order. Two poles are much further from the imaginary axis compared with other five poles in the pole loci of the 7thorder model, so the model is reduced to a 5thorder. A comparison of simulation and experiment results showed that the 5thorder model matches the real system well.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call