Integrated Completion Sensitivities for Horizontal-Well Design in the Vaca Muerta

Abstract

This article, written by JPT Technology Editor Chris Carpenter, contains highlights of paper SPE 185499, “Fracturing-to-Production Integrated Completion Sensitivities for Horizontal-Well Design in the Vaca Muerta Shale,” by S. Pichon, F. Cafardi, G.D. Cavazzoli, A. Diaz, and M.R. Lederhos, Schlumberger, prepared for the 2017 SPE Latin America and Caribbean Petroleum Engineering Conference, Buenos Aires, 17–19 May. The paper has not been peer reviewed. The boom in organic shale plays has revealed the critical need to size hydraulic-fracture treatments correctly to achieve commercial success. The right balance must be found between the cost of fracturing and the additional production achieved by increasing the formation-to-wellbore contact area. The complete paper examines a range of completion scenarios to evaluate the relationship between hydraulic-fracture design, production, and well profitability by use of numerical simulations to guide completion of horizontal wells in Argentina’s Vaca Muerta Shale. Introduction The Vaca Muerta Shale is the source rock of most of the producing formations in the Neuquén Basin, with high potential as a standalone reservoir. The first well aiming at testing production from the play was drilled and completed in 2010, and, at the end of 2016, the production from the formation involved more than 600 wells. Well-construction practices have moved from creating vertical wells to creating horizontal wells. In any organic shale play, completion has a significant weight in the total well cost and must be sized adequately. Completion design is composed of the volume and number of hydraulic fractures to be created along the lateral, and it must be engineered according to the specific features of each formation. One of the principal features of an organic shale reservoir is the absence of commercial production unless the well is hydraulically fractured. Enhancing the contact area between the formation and the wellbore with hydraulic fractures compensates for the extremely low permeability of these formations. Multiple factors, including geomechanics and stress direction, drive the geometry of the hydraulic fractures. However, it must be noted that most organic shale reservoirs are overpressured. This factor tends to drive the stresses up and reduce their horizontal anisotropy. Besides the hydraulic-fracture geometry, production is also the result of the hydrocarbon volume in place and the interaction of the flow capacities between the reservoir and the created network of conductive fractures. Therefore, the size of this surface of exchange created by the hydraulic fractures has a critical effect on the level and dynamics of the production profile. Finally, economics is the balance between total well cost and production. The completion design affects both production and total well cost, making it a critical parameter. Fracturing-to-Production Integrated Work Flow Work-Flow Requirements. With the primary objective being the combined evaluation of completion design, hydraulic-fracture geometry, production, and economics, the methodology must allow an explicit description, at either the input or output level, of each one of the aforementioned parameters. The fracturing-to-production work flow fits this purpose and is proposed for this study. The work flow has been implemented successfully in the Vaca Muerta and various other shale plays.