Abstract

Millimeter wave (mmWave) bands formulate the standalone (SA) operation mode in the new radio (NR) access technology of 5G systems. These bands rely on beamforming architectures to aggregate antenna array gains that compensate for dynamic channel fluctuations and propagation impairments. However, beamforming results in directional transmission and reception, thus resulting in beam management challenges, foremost initial access, handover, and beam blockage recovery. Here, beam establishment and maintenance must feature ultra-low latencies in the control and data planes to meet network specifications and standardization. Presently, existing schemes rely on arrays redundancy, multi-connectivity, such as dual-beam and carrier aggregation, and out-of-band information. These schemes still suffer from prolonged recovery times and aggregated power consumption levels. Along these lines, this work proposes a fast beam restoration scheme based on deep learning in SA mmWave networks. Once the primary beam is blocked, it predicts alternative beam directions in the next time frame without any reliance on out-of-band information. The scheme adopts long short-term memory (LSTM) due to the robust memory structure, which uses past best beam observations. The scheme achieves near-instantaneous recovery times, i.e., maintaining communications sessions without resetting beam scanning procedures.

Highlights

  • Introduction10 gigabits/sec (Gbps) throughput rates, 1 ms latency, improved energy efficiency, and higher density, as specified by the third-generation partnership project (3 GPP)

  • The new radio (NR) access technology for 5G systems includes the support of10 gigabits/sec (Gbps) throughput rates, 1 ms latency, improved energy efficiency, and higher density, as specified by the third-generation partnership project (3 GPP)

  • This paper proposes a novel beam recovery scheme in highly directional standalone (SA) mmWave networks that is projected for the second phase of 5G

Read more

Summary

Introduction

10 gigabits/sec (Gbps) throughput rates, 1 ms latency, improved energy efficiency, and higher density, as specified by the third-generation partnership project (3 GPP). The use of pencil beams results in significant challenges in the user detection process and is attributed to the low reflection coefficients for reflected mmWave signals in non-line-of-sight (NLoS) environments that results in a sparse structure Along these lines, fast beam-tracking and handover solutions are required here to enhance the signal quality, compensate for the path loss and overcome link blockages and provide fast link restoration without dropping the communication sessions in the network. The scheme achieves near-instantaneous recovery times, low power consumption, and energy-efficient levels without relying on out-of-band information or any auxiliary information This is realized at power-efficient beamformers at the MS, based on uniform circular arrays (UCA) to account for the sparse channel structure.

Limitations
Beam Recovery Schemes Based on Deep Learning Networks
Beam Recovery Schemes Using Out-of-Band Information
Beam Recovery Schemes in Indoor mmWave Networks
Beam Recovery Schemes Based on Network Infrastructure
Beam Recovery Schemes Based on User Mobility
Beamforming Models
Signal and Channel Models
Blockage Model
Proposed LSTM-Based Recovery Scheme
Network Architecture
Proposed
Simulation Results and Performance Evaluation
LSTM-based
Recovery Times
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call