In-situ oxygen generation using Titanium foam/IrO2 electrode for efficient sulfide control in sewers

Abstract

Hydrogen sulfide (H2S) causes corrosion of pipeline network and endangers sewer’s normal operation, while the rehabilitation or replacement of sewer network incurs expensive manpower and material costs. Conventional chemical dosing strategies such as oxygen injection and caustic soda addition, confront issues with transport and storage of chemical reagents as well as dose control. In contrast, electrochemical treatment techniques have evoked growing attention in sewer management due to its capacity of in-situ effective agent production, real-time dose control and amenability to automation. In this study, the performances of anodic oxygen production using Ti/IrO2 and Titanium foam/IrO2 as electrodes were investigated. Titanium foam/IrO2 electrode exhibited the superior oxygen evolution capacity, with the dissolved oxygen (DO) level attained in the range 8–9 mg L-1 (i.e., higher than that of 5–6 mg L-1 by Ti/IrO2 electrode). It was also indicated that a decrease in flow rate or an increase in current density would accelerate its in-situ oxygen production. DO production with the presence of COD, NH4+, HCO3−, H2PO4−/HPO42− was approximately 6.78–8.37 mg L-1. Moreover, this electrochemical method was illustrated to successfully achieve sulfide removal efficiency of 90 % in the simulated sewage experiment. The cathode compartment simultaneously produced caustic soda (∼0.4 wt% in 210 min), thereby contributing to further sulfide removal. Additionally, the effect of real sewage with different conductivities on sulfide removal proved the wide applicability of electrochemical technology in sewer management. Overall, this study demonstrated the practical potential of concurrent in-situ anodic oxygen production and cathodic caustic soda generation for sulfide control in sewers.