Insight into Type IV cracking in Grade 91 steel weldments

Abstract

In this work, an insight into the premature Type IV cracking was undertaken to clarify its mechanisms in Grade 91 steel pipe weldments. High-resolution microscopy observations of the as-welded heat-affected zone (HAZ) reveal that the commonly recognized fine-grained region susceptible of cracking on the edge of HAZ belongs to the inter-critical HAZ (ICHAZ), rather than the fine-grained HAZ (FGHAZ). Instrumented indentation tests uncover that the ICHAZ is the weakest region across the weld, exhibiting the largest displacement and the lowest hardness in three thermal stages. Localized deformation of matrix grains and high stress triaxiality in the ICHAZ promoted nucleation of creep cavities along grain boundaries. This localized deformation was induced by the creep strength mismatch of matrix grains with different Cr concentrations. Cavity-free regions exhibit a relatively homogenous Cr distribution, whereas, an inhomogeneous Cr distribution is observed in the cavity-containing regions. It is believed that this local Cr inhomogeneity in the ICHAZ is caused by the partial dissolution of Cr-rich M23C6 carbides and an insufficient homogenization during rapid welding thermal cycles.