Abstract
The paper intended to research the influences of paper in UV ink-jet printer, mainly including the height and glossiness. Results proved that infiltrations had all appeared between three selected substrates of paper, on which the paper roughness and bulkiness had a linear effect. And the infiltration on the first layer of ink was bigger than those on other layers of ink. It is too stable to not be changed by the paper that the infiltrations between two layers of ink. As we knew, paper roughness and bulkiness would reduce the glossiness. There existed ink sticks on the third layer of ink and more, even some ink holes when the infiltrations were too big because of the substrate of paper had a bigger roughness and bulkiness. Therefore, the substrates used for UV ink-jet 3D printing should have a property of tight and smooth, and the first layer of ink must not be calculated in the whole height of model, so that the printing result would be satisfied.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
