Abstract
Abstract This paper explores the influence of structural parameters of ultrasonic transducer on the frictional plasticizing heat generation of polymer particles. A three-dimensional model of the interfacial friction plasticizing heating was established, and a transducer with different structural parameters was designed and analyzed. The actual output longitudinal vibration excitation of the transducer obtained by simulation analysis was directly loaded into the heating model, which further investigated the effect of various structural parameters on the frictional plasticizing heating process and temperature distribution of polymer particles. The results demonstrated that the interfacial friction plasticizing heating temperature of polymer particles increases nonlinearly with the longitudinal vibration excitation time, and the heat generation is a transient process. The amplification ratio has the greatest influence on the interfacial friction plasticizing heating rates of polymer particles, followed by both front cover length and piezoelectric ceramic pieces thickness; the effects of length of rear cover, horn and ultrasonic tool head are the smallest. The present work provides an effective basis for further studying the ultrasonic plasticizing of polymer particles in ultrasonic micro-molding.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.