Abstract
The results of the study of the influence of temperature and pressure of injection molding on the properties and volume shrinkage of nanocomposites based on linear low-density polyethylene and natural mineral fillers are presented. A copolymer of ethylene with butylene, a copolymer of ethylene with hexene, and such natural Azerbaijan minerals as vesuvianite and clinoptilolite were used as raw materials.
Highlights
Влияние технологического режима литья под давлением на свойства нанокомпозитов на основе линейного полиэтилена низкой плотности и природных минералов
Influence of the technological mode of injection molding on the properties of nanocomposites based on linear low density polyethylene and natural minerals
The results of the study of the influence of temperature and pressure of injection molding on the properties and volume shrinkage of nanocomposites based on linear low-density polyethylene and natural mineral fillers are presented
Summary
Влияние технологического режима литья под давлением на свойства нанокомпозитов на основе линейного полиэтилена низкой плотности и природных минералов. Приводятся результаты исследования влияния температуры и давления литья под давлением на свойства и объемную усадку нанокомпозитов на основе линейного полиэтилена низкой плотности и природных минеральных наполнителей. При оценке влияния технологического режима на свойства нанокомпозитов в качестве объекта исследования использовали СЭБ + 5,0% масс.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have