Abstract
The topography of the active surfaces in rolling contact depends on the surface roughness obtained by different manufacturing process technology (turning, grinding, polishing, lapping, etc.). The aim of this paper work is to evidence the influence of the surface roughness on surface geometry of rolling contacts. The experimental tests were carried out on the AMSLER machine and an experimental setup for pure rolling motion. The surfaces of the rolling samples were analyzed with SEM (scanning electron microscopy) and EDS (energy dispersive X-ray spectroscopy) techniques for structural and chemical analysis and measured with the Taylor Hobson profilometer before and after the experimental tests for surface topography.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
