Abstract
One of the most serious causes of accidents in furniture making is kickback of machined material. The aim of this study was to determine the influence of the milling tool setup on hazards associated with kickback in furniture making. The speed of kickback was accepted as the measure of these hazards. The experiment involved controlled changes in milling tool setup, projection of cutting knives over the body of the milling tool, number of cutting knives and clearance angle. Multifactor analysis of variance was applied to the results of individual experiments, showing statistically significant factors and their interactions. Inspection and analysis of traces left by the cutting knives of the tools on the test pieces made of wood materials supported inferential statistics. The obtained results verified some common opinions and ideas on the impact of the milling tool setup on the hazards resulting from kickback in furniture making.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Occupational Safety and Ergonomics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
