Abstract

This randomized clinical study examined the influence of the gingival condition—healthy versus mild inflammation—on sulcus representation and possible gingival recession for two gingival displacement procedures prior to conventional impression making. The interventions double cord technique or a kaolin paste containing aluminum chloride were applied to 40 probands. The opposite quadrant served as intrapersonal reference (split-mouth design). Precision impressions were then made. Extraoral digitization of the plaster models resulting from the reference impression prior to gingival displacement, the intervention impression and control impressions were the basis for the computer-aided three-dimensional analysis. After six months, a mild artificial gingivitis was induced, and the contralateral quadrant (cross-over design) was examined for the intervention. The gingivitis deteriorated the sulcus representation for the double cord technique group but did not affect the paste technique group. The gingival condition had no influence on the marginal gingiva height changes. The minor extent of those changes, which were measured up to six months after intervention at the palatal study site, were not considered to be in the clinically relevant range for gingival recession. For healthy gingiva, the cord technique showed superior sulcus representation compared to the paste technique. This advantage was lost to a great extent under the conditions of mild gingivitis.

Highlights

  • Whenever restorations are necessary for teeth with subgingival margins, sufficient gingival displacement is an essential requirement prior to precision impression making

  • Artificial gingivitis was induced in each proband and the same intervention was repeated in the contralateral quadrant

  • The aim of the present clinical study was to determine the influence of the gingival condition—i.e., healthy versus mild inflammation—on sulcus representation and possible occurrence of gingival recession for two gingival displacement techniques: the cord displacement technique with astringent and the cordless technique with a kaolin clay-based paste

Read more

Summary

Introduction

Whenever restorations are necessary for teeth with subgingival margins, sufficient gingival displacement is an essential requirement prior to precision impression making. For this purpose, the impression material must flow into the sulcus in sufficient quantity and to a sufficient depth to enable a precise reproduction of the die [1]. Two widely used procedures are the retraction cord technique [2,3,4] and the cordless technique with paste, foam or gel [5]. Paste, foam or gel are injected into the sulcus for gingival displacement

Objectives
Methods
Results
Discussion
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.