Abstract
Nonevaporable thin film getters based on the elements of the fourth and fifth columns of the periodic table were deposited by sputtering. Among the some 20 alloys studied to date, the lowest activation temperature (about 180 °C for a 24 h heating) was found in the Ti–Zr–V system with a well-defined composition range. Characterization of the activation behavior of such Ti–Zr–V films is presented. The evolution of the surface chemical composition during activation is monitored by Auger electron spectroscopy and the functional properties are evaluated by pumping speed measurements. The pumping speed characteristics are quite similar to those already measured for commercially available nonevaporable getter materials, except for the much lower saturation coverage for CO. This inconvenience, which is due to the smooth surface structure of these films, can be counteracted by increasing the roughness of the substrate.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
