Influence of the chamber inclination angle and heat-generating element location on thermal convection of power-law medium in a chamber

Abstract

PurposeThis paper aims to study the mathematical modeling of passive cooling systems for electronic devices. Improving heat transfer is facilitated by the correct choice of the working fluid and the geometric configuration of the engineering cavity; therefore, this work is devoted to the analysis of the influence of the position of the heat-generating element and the tilted angle of the electronic cabinet on the thermal convection of a non-Newtonian fluid.Design/methodology/approachThe area of interest is a square cavity with two cold vertical walls, while the horizontal boundaries are adiabatic. An element of constant volumetric heat generation is placed on the lower wall of the chamber. The problem is described by Navier–Stokes partial differential equations using dimensionless stream function and vorticity. The numerical solution is based on the developed computational code using the finite difference technique and a uniform rectangular grid.FindingsThe key conclusions of this work are the results of a detailed analysis of streamlines and isotherms, the average Nusselt number and profiles of the average heater temperature. It was found that more intensive cooling of the heat-generating element occurs when the cavity is filled with a pseudoplastic fluid (n < 1) and not inclined (α = 0). The Rayleigh number of Ra = 105 and the thermal conductivity ratio of k = 100 are characterized by the most positive effect.Originality/valueThe originality of the research lies in both the study of thermal convection in a square chamber filled with power-law fluid under the influence of a volumetric heat production element and the analysis of the influence of geometric and thermophysical parameters characterizing the considered process.