Abstract
SUMMARYDisplacement measurement‐based estimations of loads and utilization degrees in shotcrete tunnel shells as part of the New Austrian Tunneling Method (NATM), have become standard tools in tunnel practice; their quality, however, may crucially depend on the knowledge of the actual shotcrete composition after spraying. To shed light on this issue, we here determine, based on experimentally validated micromechanical representations of shotcrete, the hydration degree‐dependent elastic, creep, and strength properties of different shotcretes, characterized by water cement ratios (w/c) between 0.4 and 0.6, aggregate cement ratios (a/c) between 3.5 and 5, and Young's modulus of aggregates (Eagg) between 40 and 80 GPa. These properties are fed into a structural shell model of the Sieberg tunnel, and this model is subjected to displacement fields approximated from daily displacement measurements at five selected points along the shell's inner surface. Resulting stresses and forces in the tunnel shell allow for analyzing the influence of shotcrete composition on load‐level estimation in NATM tunnel shells: The magnitudes of circumferential and longitudinal normal forces increase significantly with decreasing w/c, while a/c and Eagg have the inverse and relatively minor effect. The utilization degree is virtually insensitive to changes in w/c(especially at early ages), and only slightly decreases with decreasing a/c and Eagg. The location of maximum loading is unaffected by the shotcrete composition underlying the analysis. Conclusively, location and magnitude of maximum utilization degrees are very robust estimates (not affected by limited knowledge on the shotcrete composition), whereas realistic estimation of stresses and forces does require more accurate consideration of shotcrete composition. Copyright © 2011 John Wiley & Sons, Ltd.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal for Numerical and Analytical Methods in Geomechanics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.