Abstract
Contact materials for electrical switch gears are widely used for connecting and disconnecting electric circuits. These contacts are two component systems, where the contact tips are brazed to the carriers prior to installation. The contacts used in the present work is a 3 layered sandwich structure consisting of a silver-tin oxide (Ag-SnO2) layer, a silver (Ag) inter-layer and a thin layer of the braze. The carrier itself is copper (Cu) - plated steel. The brazing process is accomplished by a high frequency inductive heating process. By varying the brazing parameters, namely, temperature and time, their influence on joint formation is investigated. The brazing joint of the contact tips were characterized by microscopy (light and electron microscopy) and physical analytical techniques (energy dispersive X-ray analysis. The mechanical characteristics were determined with Vickers micro-hardness. Investigations indicated that, comparatively, the variations in temperature had a greater influence on joint zone formation and their mechanical properties. It was further demonstrated that the extended hold times lead to a higher degree of joint zone filling due to a large reduction in pore volume fraction.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
