Abstract
The influence of process parameters in the three-stage purification of aluminate solution from the Bayer process and aluminum hydroxide was considered in this paper. One of the ways of purification is treating the aluminate solution in order to reduce the concentrations in the starting raw material (solution) and then treating the aluminum hydroxide at a certain temperature and time in order to obtain an alumina precursor of adequate quality. The purification process itself is divided into three phases. The first phase involves the treatment of sodium aluminate with lime in order to primarily remove Ca2+ and (SiO3)2− impurities. Phase II aims to remove impurities of Zn2+, Fe2+, and Cu2+ by treatment with controlled precipitation using specially prepared crystallization centers. In Phase III, Na+ is removed by the process of hydrothermal washing of Al2O3 ∙ 3H2O. In this work, parameters such as temperature (T), reaction time (t), and concentration of lime (c) were studied in order to remove the mentioned impurities and obtain the purest possible product that would be an adequate precursor for special types of alumina.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
