Abstract
This study investigated the influence of printing parameters and strategies on the morphological characteristics of austenitic stainless steel beads deposited on carbon steel substrates, using plasma directed energy deposition (DED). The experimental setup varied the welding current, wire feed speed, and torch travel speed, and we analyzed three printing strategies: simple-linear, overlapping, and oscillating. Moreover, advanced 3D scanning and computational analysis were used to assess the key morphological features, including bead width and height. The results showed that the computational model developed by using parabolic assumptions accurately predicted the geometric outcomes of the overlapping beads. The oscillating printing strategy was the one that showed improved morphological uniformity and bead substrate wettability, so these features were used for multi-layer component manufacturing. The use of equivalent wavelength–amplitude values resulted in maximum combinations of bead height and width. Moreover, cost-effective carbon steel substrates were feasibly used in microstructural and elemental analyses, with the latter ones confirming the alignment of the bead composition with the wire-fed material. Overall, this study provides practical insights for optimizing plasma DED processes, thus enhancing the efficiency and quality of metal component manufacturing.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
