Year-end Sale % OFF 
Abstract
Although overlay coatings deposited via plasma transferred arc welding (PTAW) can effectively prolong the service life and improve the performance of components, cracks and pores tend to occur in the high-hardness and wear-resistant coating during the deposition process. Further treatment is thus necessary to improve the coating quality. Herein, PTAW-deposited Ni-based overlay coating was remelted using plasma transferred arc (PTA) under different remelting currents (RCs). The microstructure and phase composition of the coatings were investigated via metallographic microscopy and x-ray diffraction. The hardness, surface quality, and wear resistance of the coatings were also tested. The results show that PTA remelting could effectively eliminate the defects and improve the coating properties when the RC was controlled within a given interval (100-120 A). The type and content of the hard phase in the remelted coating were increased to enhance the microhardness and wear resistance. However, remelting with excessive currents resulted in the agglomeration and growth of the hard phases, which negatively affected the coating hardness and wear resistance. The proper use of PTA remelting technology to treat PTAW-deposited overlay coating is an effective approach for eliminating the coating defects and enhancing the coating properties.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
