Abstract
We compared the surface free energies and enamel bond strengths of single-step self-etch adhesives with and without an oxygen-inhibited layer. The adhesives were applied to the enamel surfaces of bovine incisors, light irradiated, and the oxygen-inhibited layer was either retained or removed with ethanol. The surface free energies and their components (γ(S)(LW), γ(S)(+), and γ(S)(-)) were determined by measuring the contact angles of three test liquids placed on the cured adhesives. The enamel bond strengths of specimens with and without the oxygen-inhibited layer were measured. For all surfaces, the value of the estimated surface tension component γ(S)(LW) was relatively constant. The value of the γ(S)(+) component increased slightly when the oxygen-inhibited layer was removed, whereas that of the γ(S)(-) component decreased significantly. The enamel bond strengths of the self-etch adhesives were significantly lower in the specimens without an oxygen-inhibited layer. The oxygen-inhibited layer therefore appeared to promote higher enamel bond strength.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.