Abstract
An experimental investigation is reported to establish the influence of orientation on thermal behaviour of phase change material (PCM) in a shell and tube type Latent Heat Storage Unit (LHSU). An angle adjuster is provided in the experimental test facility to orient the LHSU at different angles. Stearic acid is used as PCM (melting point −55.7 to 56.6 °C) and water is used as a heat transfer fluid (HTF). Total 45 thermocouples are embedded in the annulus to measure the PCM temperature in axial, radial and angular direction. Comparison of melting behaviour of PCM for different orientation is reported in terms of radial, axial and average temperature distribution. It is observed that half of the PCM mass melts rapidly for horizontal orientation (θ = 0°) of LHSU owing to strong natural convection in the upper half of the horizontal diametric plane. It is also established that for the case when the LHSU is oriented at θ = 45°, the average PCM temperature is higher compared to other inclinations for the same HTF inlet condition. Hence the melting time required is the lowest for this orientation. Energy storage rate which decides the use of LHSU in large scale solar thermal applications, is significantly influenced by orientation.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
