Influence of heavy metals on the formation and the distribution behavior of PAH and PCDD/F during simulated fires

Abstract

Combustion experiments were performed with an artificial fire load (polystyrene and quartz powder) in a laboratory scale incinerator in the presence of gaseous HCl to simulate accidental fire conditions. The aim of this investigation was to trace back the alterations of the formation and the distribution behavior of PAH and PCDD/PCDF to the presence of CuO or a mixture of metal oxides (CdO, CuO, Fe 2O 3, PbO, MoO 3, ZnO). The total amount of the 16 PAH target compounds was reduced by the factor of 5–9 when the mixture of metal oxides was present rather than merely CuO. PAH patterns as well as their distribution behavior were significantly influenced by these oxides. In general, transportation inside the installation was enhanced for most of the 16 analyzed PAH. Only fluorene and dibenzo[ a, h]anthracene were transported to a smaller extent. In contrast to PAH, total concentrations of PCDD were increased by factor 9 and of PCDF by factor 10, respectively, when CuO was present. Adding the mixture of metal oxides resulted in an increase of PCDD by factor 14 and of PCDF by factor 7. CuO and the mixture of metal oxides had a different influence on the PCDD/F homologue patterns. For instance, the HxCDF to OCDF ratio after incineration without any metal oxide was 1 to 6, whereas addition of CuO or the mixture of the metal oxides shifted the HxCDF to OCDF ratios towards 1 to 40 or 1 to 17, respectively. Combustion along with CuO increased transportation of higher chlorinated PCDF congeners, whereas the mixture of the metal oxides caused a strong decrease of PCDF distribution throughout the system.