Influence of freestream turbulence on boundary layer transition over a controlled-diffusion compressor blade

Abstract

The influence of inlet freestream turbulence (FST) on the boundary layer transition over the suction surface of a controlled-diffusion compressor blade is demonstrated here by employing a well-resolved large-eddy simulation. Inherent to low Reynolds number conditions, a laminar separation bubble (LSB) forms on the suction surface, attributing to substantial flow diffusion. Inlet FST levels ranging from 1.5% to 7.6% are systematically varied, while maintaining a constant Reynolds number based on axial chord and inlet velocity at 2.1 × 105. Transition of the shear layer is initiated via Kelvin–Helmholtz instability with the amplification of selective frequencies until an inlet FST of 2.3%. Secondary instability emerges in the second half of the LSB, attributed to the amplification of perturbations in the braid region, ultimately leading to breakdown near the reattachment. At a moderate FST level of 4.2%, longitudinal streaks in the first half of the blade elongate downstream, causing the LSB to disappear, while the flow becomes inflectional at the mid-chord. Thus, the boundary layer transition in the second half of the blade is attributed to the high receptivity of the inflectional layer and breakdown of streaks, leading to an exponential growth of disturbances. Finally, at an inlet FST of 7.6%, the boundary layer appears pre-transitional in the first half of the blade, exhibiting significant turbulence levels. In the latter half, excitation occurs primarily through the breakdown of streaks, reflecting an algebraic growth of disturbances. Flow features and oscillations in the Nusselt number in this case suggest the outer mode of streak-induced instability.