Abstract
Understanding the two-phase displacement behaviors of oil and water in porous media under different reservoir development modes for enhanced oil recovery is essential. In this paper, the influence of development measures, such as increasing the injection rate, changing the inlet/outlet position, increasing the water viscosity, and reducing the surface tension coefficient, on oil–water dynamic behaviors was studied using a numerical simulation based on the study of the formation of a high-water-cut channel by water flooding at different injection rates. The results show that blockage and restart occur during displacement in the pore–throat channel and during staggered displacement in different pore channels. With an increase in the injection rate, the recovery increases first and then decreases. All the different development measures can increase the swept area and recovery factor. The recovery factor increases significantly by reducing the surface tension coefficient at medium/high injection rates (≥0.01 m/s) and by increasing the viscosity of the water at low injection rates (<0.01 m/s). The numerical simulation study preliminarily revealed the influence of different development measures on displacement behaviors in the pore model. It thus provides theoretical support for understanding the law of oil and water movement in reservoirs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
